All members of Litong have been working hard since the outbreak of the epidemic. From January to May, they reached the highest record since the company was established, with a monthly output of 2 million meters. These achievements are inseparable from everyone's hard work. Since construction started this year, there are still problems on the production line due to increased production from new projects, many new employees. Bleeding, sweating and tears. The multifunctional hose is never required, almost all means of transport can be safely transported through it, even corrosive liquid chemicals (sulfuric acid, hydrochloric acid, sulfur reagents, etc.) will not corrode. It cleans itself well and has maximum resistance to sticky substances (whether glue or grease) and is not sticky. It can withstand high pressure, the safety factor is 4 times, the inner diameter is 2 inches, and it can easily withstand the pressure of 25MPa. It is safe, powerful and proprietary, ideal for chemical, food and high temperature operations. According to the manufacturing process of four-layer winding high pressure hydraulic hose, Litong API 16D hose uses fire-resistant rubber as the raw material for the outer rubber layer of the hose, and is covered with stainless steel armor on the outside of the hose. The pipe body acquires fire resistance and fire resistance. Double layer frosted material injection pipe: This pipe body is mainly used in steel mills, mining and so on. The inside of the pipe body is made of black NR rubber with electrical conductivity, which has good wear resistance, and the outer layer of the pipe body is made of black SBR/NR mixed conductive rubber with wear resistance and oxidation resistance. Continue to work under a constant pressure of 10Bar (150PSI), and the middle of the tube is reinforced with a double-layer fiber textile cord with high tension. The water cutting hose can also be called an ultra-high pressure hose. When the water is pressurized to 100MPa in a special equipment, a sharp water jet can be formed through the ultra-high pressure hose (water cutting hose) and a specially made joint. The water jet can be used to cut steel, bulletproof glass, stone, and can be used for certain processes before engraving. Because of the ultra-high pressure, the blasting coefficient is required to be more than 3 times the normal working pressure, so it will undergo strict quality screening before leaving the factory to ensure the safety in use. 240PSI food and beverage suction and discharge pipe, the hose is mainly used for the suction and discharge of edible fluid media, but the pipe body is especially suitable for the application of alcohol, but the alcohol content cannot be higher than 95 degrees. The inside of the tube body is made of white non-toxic CIIR rubber that meets FDA and 3A requirements, and the outer layer is made of wear-resistant, oxidation-resistant white EPDM rubber. strengthen. As a supporting customer of heavy industry, Litong Hydraulics provides quality assurance for heavy industry machinery manufacturing. The hose is used in the project: Hercules 12,000m/year and various high-pressure hydraulic hoses. 2-layer braided tube more than 600,000 pulses; 4/6-layer winding tube more than 1.2 million pulses. Not only meet the requirements of customer equipment, but also improve the efficiency of customer production.
Manufacturer of suction and discharge hoses?
